PassivePoE™ Injector V2 POEINJv2 (sólo inyector)
Otros modelos de la familia de PoE pasivo
PassivePoE™ Set V2 - 5,5x2,1 (standard)
PassivePoE™ Set V2 - 5,5x2,5
Características generales de la familia
Passive PoE™ is a simple way of providing power for an access point on the roof.
Passive PoE™ uses free wires in the Ethernet cable and sends the equipments
power along them to the far end. Over a short distance, its usually possible to
use the power adapter supplied as standard with the access point or with other
network elements which we wish to connect along the Ethernet cable. If the loss
of the voltage on the wiring along longer lengths of Ethernet cable is too high,
it is possible to use another more powerful power adapter, to eliminate this
loss of voltage.
How it works
The complete Passive PoE™ over Ethernet - SET contains two pieces INJECTOR and
SPLITTER. It is suitable for using with products that basically do not support
Power Over Ethernet. Passive Power Over Ethernet - SET is applicable for wide
range of network products such as Access Points, Routers, IP cameras, modems,
switches, embedded computers or other network devices.
Devices can be supplied standardly up to 50V. The power adapter is not included
- it is possible to use the power adapter of the powered device as access point,
IP camera etc. Passive PoE™ `s range is normally from 30-40 metres / 100-130 ft.
The real distance depends on the power supply, type of cable and powered device
Suitable For Installation in Panel
Our PassivePoE™ Solution allows easy integration of the ethernet connection into
face plates or panels of your devices. We provide schematic of cut-out you need
to create in the panel. Installation is easy: simple insert-andturn system.
This PassivePoE™ is our original solution. Avoid using low-cost or anonymous
copies in order to avoid the risk of damaging your device. We deliver Injector
only or Whole Set, both using standard 5.5×2.1mm DC power jack. Special order is
needed for 5.5×2.5mm version.